Install Clear Static Cling Inside Glass

Installation Guides 2min Read

These instructions list the tools and steps you'll need to know to apply Clear Static Cling on the Inside of your window facing outward. Following these "Clear Static Cling - Inside Glass" guidelines will ensure that your window cling will look amazing when installed and will last its full life expectancy.

Install supplies for Clear Static Cling Inside Glass

Tools Needed:

Two people, MASKING tape (scotch tape may damage material), squeegee, glass cleaner, and paper towels.

Preparation:

Using glass cleaner, clean windows thoroughly and allow to dry. Read installation instructions carefully. Best installed when outside temperatures are over 65F with low humidity.

Install Backlit Film Inside Glass Step 1

Step 1

Use the tape measure to find the center point at which you want to place your Clear Static Cling.

Install Backlit Film Inside Glass step 2

Step 2

Leaving the protective backing on, tape the top of the Clear Static Cling to the window, with the graphics facing away from you.

Install Backlit Film Inside Glass step 3

Step 3

Have your partner lift the Clear Static Cling while you remove a portion of the protective backing, starting from the top and pulling downward about 6". Make sure it stays taped to the window.

Install Backlit Film Inside Glass step 4

Step 4

While your partner continues to lift the Clear Static Cling away from the window, spray the surface of the window liberally with water.

Install Backlit Film Inside Glass step 5

Step 5

Have your partner lay the exposed portion of Clear Static Cling down onto the window. Continue peeling away 6" sections of the backing at a time as you squeegee from top to bottom. Once the graphic is fully-applied, squeegee from the center toward the outer edges to remove air bubbles.

Tip: Cover the squeegee with a paper towel or soft cloth to prevent it from scratching the material.

Install Backlit Film Inside Glass step 6

Step 6

Remove the masking tape and squeegee the top of the Clear Static Cling. Finish by wiping down the edges of the cling with a paper towel to remove excess moisture.

Install Backlit Film Inside Glass installed

Step 7

You're done! Once the installation is complete, your unique Clear Static Cling is ready to grab attention.

Perfecting Your Clear Static Cling:

Clear Static Clings are easy to remove and reposition if you are not happy with the installation. Gently remove and reposition your cling as desired, making sure the material never touches itself. The cling may show some streaks immediately after installation until it has fully cured, which takes up to 2 weeks. By this time, any streaks should have disappeared.

If you would like to reuse your static window cling, we recommend storing the paper backing and packaging for safe storage.